Support
Sub Categories
0.5% Accuracy. Overload Fuse protection. Test Clips/Direct insert jack for easy measurement.
World-Class Optical Performance Wavelength range: 600 to 1700nm High wavelength accuracy: ±0.01nm High wavelength resolution: 0.02nm Wide dynamic range: 78dB typ. Wide level range: +20 to -90dBm Fast measurement: 0.2 sec. (100nm span) Applicable to single-mode and multimode fibers Related Products Optical Wavelength Meter Offers higher Wavelength Accuracy, but reduced span, and sensitivity compared to the AQ6370D OSA
Features * Wide frequency range from 1uHz to 80/50MHz* High 200MSa/s sampling rate * 16-bit Amplitude Resolution* Output from any section of 1M-point-long waveforms* 4.3" high resolution LCD display/on-screen help/Impedance switch* Four ways to generate arbitrary waveforms: Front Panel Operation CSV file uploading, Direct Waveform Reconstruction (DWR), ArbitraryWaveform Editing PC Software * USB, RS-232, GPIB interface support
3 channel inputs for the simultaneous recording of Leakage Current, Load Current and Voltage • Power Quality analysis(only on KEW 5020)(Power Quality:Reference voltage, Swell, Dip, Short power Interruptions) Large Capacity for storing 60,000 data points 60,000 data points can be recorded when 1ch is used, and when all the three channels are used, 20,000 data points per channel can be recorded Lowpass Filter will filter out the harmonics(Cutoff Frequency = Approx. 160Hz) LED flickers when the preset current / voltage value is exceeded CALL: Confirmation of recorded data • The following can be displayed: number of recorded data points, (max+ min+ peak) value for each channel complete with time/date information in the Normal recording mode. (Detected values (i.e. when values are outside preset limits ) can be displayed in other recording modes) • RECALL: The last 10 recorded data points including time/date can be recalled on the logger display
GMS-1000 is one point digital controller which can be connected to only one(1) gas detector. Receiving analogue continuous signal from one (1) detector and converting it into digital signal, GMS-1000 provides various alarming and monitoring environment by micro-processor. Also, GMS-1000 converts digital signal into the 4-20㎃ standard current signal for output signal which can be transmitted to various external devices such as PLC, DDC, RECODER, and so on. Using these functions, you can easily construct the gas monitoring system more extensive as well as more comprehensive.
Panel type DO analyzer in a compact DIN 96 size One-touch calibration and various self-diagnostic functions 2-point contacts signal, 4 - 20mA output (RS-232 optional) Power supply: 90 - 264VAC, 50/60Hz Meas. range Minimum : 0 - 1 mg/L Maximum: 0 - 50 mg/L
Temperature Range : -100 to 1,700 ℃ (Type k to Type R / S) • Accuracy : ± ( 0.4 % + 1 ℃ ) • Weight : 489 g/1.08 LB. • Dimension : 177 x 68 x 45 mm
The GS610 is a highly accurate and highly functional programmable voltage/current source that incorporates voltage/current generation and measurement functions. The maximum output voltage and current are 110 V and 3.2 A, respectively. Evaluation of over a wide range of basic electrical characteristics is possible, because the GS610 can operate as a current source or a current sink.